SNA Link/iX Node Managers Guide (30291-90507)

238 AppendixA
Messages
SNA Transport Logging Messages
MESSAGE: Shutdown type = Quiesce
CAUSE: This is part of the logging messages “Node
NodeName all
sessions closed — beginning shutdown” and “Node
NodeName shut down
completed” (each message is described earlier in this listing). This
message indicates the type of shutdown (quiesce) that is in progress.
ACTION: None.
MESSAGE: SIDH = SessIDHi , SIDL = SessIDLo ,ODAI OAFDAFAssgnInd
CAUSE: This is part of the OpenUser/CloseUser logging messages. It
uniquely identifies the session.
ACTION: None; this is a normal event.
MESSAGE: SNA PACKET REJECTED ON NODE
NodeName BY
MODULE
ModuleNum
CAUSE: A packet intended for the LU-LU session was sent on the
LU-SSCP session. The LU-LU session is not available, since no SNA
service has opened the session yet. So, the packet was rejected.
ACTION: Call your Hewlett-Packard support contact.
CAUSE: The remote system is configured to send a welcome screen
immediately after receiving the ACTivate Logical Unit (ACTLU)
response. When this is the case, the welcome screen is rejected with
sense 1003.
ACTION: None; this is a normal event. The welcome screen is
retransmitted by the remote system when the LU-LU session is
established.
MESSAGE: SNA Transport received exception event from LLC on
node
NodeName
CAUSE: An exception event caused the token ring LLC level to shut
down.
ACTION: Software internal error. Submit node trace, SNA/Transport
version, NMCONFIG.PUB.SYS, and console logging list to the
Hewlett-Packard support contact.
MESSAGE: SOCKERR
nnn
CAUSE: This is part of the logging message “subsystem = SubsysID ,
procedure =
ProcNum , error num = ErrorNum ” when the ProcNum is -1
(the message is described later in this listing).
ACTION: Look in the NS 3000/XL Error Messages Reference Manual for
the message with the number corresponding to
nnn .