SNA Link/iX Node Managers Guide (30291-90507)

220 AppendixA
Messages
SNA Transport Error Messages
SNAERR 9 MESSAGE: No available AFT entry. (SNAERR 9) No room left in
current stack segment for another AFT.
CAUSE: An SNAOpenUser was attempted, but no room for another
Available File Table (AFT) entry is available in the current stack
segment.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 10 MESSAGE: Bad PI in RH. (SNAERR 10) The Pacing indicator was set
in the RH sent to SNA Transport.
CAUSE: The pacing indicator (PI) was set in the Request/Response
Header (RH) passed to one of the SNA Send intrinsics.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 11 MESSAGE: Bad BCI in RH. (SNAERR 11) An improper chaining
sequence occurred.
CAUSE: The Begin Chain Indicator (BCI) was not set in the Response
Header (RH) passed to one of the SNA Send intrinsics when sending a
response.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 12 MESSAGE: Bad ECI in RH. (SNAERR 12) An improper chaining
sequence occurred.
CAUSE: The End Chain Indicator (ECI) was not set in the Response
Header (RH) passed to one of the SNA Send intrinsics when sending a
response.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 13 MESSAGE: Bad EDI in RH. (SNAERR 13) Attempt was made to send
enciphered data.
CAUSE: The Enciphered Data Indicator (EDI) was set in the Request
Header (RH) passed to one of the SNA Send intrinsics when sending a
request.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 14 MESSAGE: Reserved bits in RH must be set to zero. (SNAERR 14
CAUSE: Various reserved bits in the Request/Response Header (RH)
were incorrectly set by the calling SNA service when making a call to
the SNA Send intrinsics.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.