SNA Link/iX Node Managers Guide (30291-90507)

Appendix A 213
Messages
SNACONTROL Error Messages
SNACIERR 72 MESSAGE: CAN’T SPECIFY “LINK=CONFIGURATION” HERE.
(SNACIERR 72)
CAUSE: The LINK=CONFIGURATION parameter was specified in an
SNACONTROL AUTODIAL, SNACONTROL START, SNACONTROL STOP,
SNACONTROL STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON,
or SNACONTROL VERSION command. None of these commands uses
LINK=CONFIGURATION .
ACTION: Reissue the command without a
LINK=CONFIGURATION
parameter.
SNACIERR 73 MESSAGE: CAN’T SPECIFY “LINK=LINKSTATE” HERE.
(SNACIERR 73)
CAUSE: The
LINK=LINKSTATE parameter was specified in an
SNACONTROL AUTODIAL, SNACONTROL START, SNACONTROL STOP,
SNACONTROL STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON,
or SNACONTROL VERSION command. None of these commands uses
LINK=LINKSTATE .
ACTION: Reissue the command without a
LINK=LINKSTATE parameter.
SNACIERR 74 MESSAGE: CAN’T SPECIFY “LINK=STATISTICS” HERE.
(SNACIERR 74)
CAUSE: The
LINK=STATISTICS parameter was specified in an
SNACONTROL AUTODIAL, SNACONTROL START, SNACONTROL STOP,
SNACONTROL STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON,
or SNACONTROL VERSION command. None of these commands uses
LINK=STATISTICS .
ACTION: Reissue the command without a
LINK=STATISTICS parameter.
SNACIERR 75 MESSAGE: CAN’T SPECIFY “LINK=DIAGSTATS” HERE.
(SNACIERR 75)
CAUSE: The
LINK=DIAGSTATS parameter was specified in an
SNACONTROL AUTODIAL, SNACONTROL START, SNACONTROL STOP,
SNACONTROL STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON,
or SNACONTROL VERSION command. None of these commands uses
LINK=DIAGSTATS .
ACTION: Reissue the command without a
LINK=DIAGSTATS parameter.
SNACIERR 76 MESSAGE: MESSAGE CATALOG FILE (CATSNA.PUB.SYS) OPEN
ERROR. (SNACIERR 76)
CAUSE: The SNA message catalog CATSNA.PUB.SYS is missing, or is not
in the correct format.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.