SNA Link/iX Node Managers Guide (30291-90507)
208 AppendixA
Messages
SNACONTROL Error Messages
SNACIERR 36 MESSAGE: CAN’T SPECIFY STYPE HERE. (SNACIERR 36)
CAUSE: The
STYPE
parameter was specified in an SNACONTROL
command; none of the commands uses STYPE.
ACTION: Reissue the command without an
STYPE
parameter.
SNACIERR 37 MESSAGE: CAN’T SPECIFY STOP TYPE HERE. (SNACIERR 37)
CAUSE: The
StopType
parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STATUS, SNACONTROL
TRACEOFF, SNACONTROL TRACEON, or SNACONTROL VERSION command.
None of these commands uses
StopType
.
ACTION: Reissue the command without a
StopType
parameter.
SNACIERR 39 MESSAGE: CAN’T SPECIFY TRACE HERE. (SNACIERR 39)
CAUSE: The
TRACE
parameter was specified in an SNACONTROL
command; none of the commands uses
TRACE
.
ACTION: Reissue the command without a
TRACE
parameter.
SNACIERR 41 MESSAGE: CAN’T SPECIFY ERROPT HERE. (SNACIERR 41)
CAUSE: The
ERROPT
parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL STATUS, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
ERROPT
.
ACTION: Reissue the command without an
ERROPT
parameter.
SNACIERR 42 MESSAGE: CAN’T SPECIFY NCB HERE. (SNACIERR 42)
CAUSE: The
NCB
parameter was specified in an SNACONTROL AUTODIAL,
SNACONTROL START, SNACONTROL STOP, SNACONTROL STOPSESS,
SNACONTROL TRACEOFF, SNACONTROL TRACEON,orSNACONTROL VERSION
command. None of these commands uses
NCB
.
ACTION: Reissue the command without an
NCB
parameter.
SNACIERR 43 MESSAGE: CAN’T SPECIFY HSCB HERE. (SNACIERR 43)
CAUSE: The
HSCB
parameter was specified in an SNACONTROL AUTODIAL,
SNACONTROL START, SNACONTROL STOP, SNACONTROL STOPSESS,
SNACONTROL TRACEOFF, SNACONTROL TRACEON,orSNACONTROL VERSION
command. None of these commands uses
HSCB
.
ACTION: Reissue the command without an
HSCB
parameter.
SNACIERR 44 MESSAGE: CAN’T SPECIFY ROUTE HERE. (SNACIERR 44)
CAUSE: The
ROUTE
parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
ROUTE
.
ACTION: Reissue the command without a
ROUTE
parameter.