SNA Link/iX Node Managers Guide (30291-90507)
186 AppendixA
Messages
SDLC Link Driver Error Messages
SDLC Link Driver Error Messages
Listed below are the messages that are generated by the SDLC link
driver. Depending on the logging configuration for the SDLC Link
subsystem, these messages are logged to the console, to disk, or both.
The messages are logged in this format:
Linkname =
LinkName
Event Type =
EventType
Log Class =
LogClass
Location =
Location
Sublocation =
Sublocation
Error Code =
ErrorCode
State =
State
Cause Status =
CauseStatus
Error Actions =
ErrorActions
(Note that
LinkName
is the same as the name of the node.) If you must
submit an CR or call your Hewlett-Packard support contact, please copy
the error
exactly as it appears on the operator’s console
; it
will make determining the cause of the problem easier.
The messages are listed below in numerical order according to
ErrorCode
.
1000 MESSAGE: The download file is too small.
CAUSE: The download file PSISDLC0.PUB.SYS or PSISDLC1.PUB.SYS is
corrupt.
ACTION: Replace the download file from your latest system update tape.
CAUSE: An incorrect version of the download file PSISDLC0.PUB.SYS or
PSISDLC1.PUB.SYS is installed.
ACTION: Check the version of the download file with NMMAINT and
call your Hewlett-Packard support contact if it is incorrect.
1001 MESSAGE: The download file is too large.
CAUSE: The download file PSISDLC0.PUB.SYS or PSISDLC1.PUB.SYS is
corrupt.
ACTION: Replace the download file from your latest system update tape.
CAUSE: An incorrect version of the download file PSISDLC0.PUB.SYS or
PSISDLC1.PUB.SYS is installed.
ACTION: Check the version of the download file with NMMAINT and
call your Hewlett-Packard support contact if it is incorrect.
1002 MESSAGE: No STEPs data structures are available.
CAUSE: A catastrophic internal resource error was found.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard support contact.
CAUSE: The host system is transmitting data before the HP e3000