SNA Link/iX Node Managers Guide (30291-90507)

Appendix A 185
Messages
SDLC Link Startup Error Messages
CAUSE: The link table does not exist.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
CAUSE: The link table has been corrupted.
ACTION: Restart the system.
22 MESSAGE: Could not unfreeze the download file
DownloadFileName .
CAUSE: Memory problems are occurring.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
23 MESSAGE: Could not close download file
DownloadFileName .
CAUSE: File system problems are occurring.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
24 MESSAGE: Manager entry not found in the system library.
CAUSE: The link software was not installed properly.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
25 MESSAGE: The link has already been started.
CAUSE: Another link of the same name is currently active. You cannot
start the same link twice.
ACTION: Stop the link and try starting it up again. If you cannot stop
the link, restart the system.
26 MESSAGE: The Path Name does not point to a PSI card.
CAUSE: The wrong path number is configured for the installed PSI card.
ACTION: Use NMMGR to correct the Physical Path for the link, or call
your Hewlett-Packard support contact to install a PSI card.