SNA Link/iX Node Managers Guide (30291-90507)

182 AppendixA
Messages
SDLC Link Startup Error Messages
questionable.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
5 MESSAGE: Could not open download file.
CAUSE: The file PSISDLC0.PUB.SYS or PSISDLC1.PUB.SYS was purged
or renamed.
ACTION: Restore the file from a backup tape and try to start the SDLC
link again.
CAUSE: The file PSISDLC0.PUB.SYS or PSISDLC1.PUB.SYS might be
opened with exclusive access.
ACTION: Wait for the program or process that has this file opened
exclusively to close it.
6 MESSAGE: Could not determine size of download file.
CAUSE: The file PSISDLC0.PUB.SYS or PSISDLC1.PUB.SYS is corrupted.
ACTION: Restore the file from a backup tape and try to start the SDLC
link again.
7 MESSAGE: Could not freeze download file in memory.
CAUSE: Memory shortage problems are occurring.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact.
8 MESSAGE: Could not open trace file
TraceFileName .
CAUSE: The indicated trace file might be invalid.
ACTION: Try specifying a different file name or let it default to
NMTC
nnnn .PUB.SYS ( nnnn is the next available four-digit number).
CAUSE: The indicated trace file might be opened with exclusive access.
ACTION: Wait for the program or process that has the trace file opened
exclusively to close it.
9 MESSAGE: Could not start trace.
CAUSE: Many causes exist; the
Status field provides more-detailed
information about the specific cause of the problem.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard support contact. You also can try running
without tracing on.
10 MESSAGE: Could not stop trace.
CAUSE: Tracing might have been turned off with the SNACONTROL
TRACEOFF command, but the link software status indicates that it was
on.