SNA Link/iX Node Managers Guide (30291-90507)

168 Chapter6
MPE Commands
SNACONTROL TRACEOFF
SNACONTROL TRACEOFF
Turns off link-level tracing, and SNA Transport node tracing.
Syntax
SNACONTROL TRACEOFF;NODE= NodeName ;LINKTRACE
;NODETRACE
;INTRINSIC= LUName
Use
SNACONTROL TRACEOFF can be issued from a session, a job, a program,
or in break. Pressing
[BREAK] has no effect on this command.
Parameters
NodeName Conditionally required. The name of the active SNA
node for which you want to turn tracing off. The name
can be up to eight alphanumeric characters long; the
first character must be alphabetic.
If only one SNA node is active, this parameter is
optional: If you do not include it, the specified tracing
for the active node is turned off. If
more than one node
is active, this parameter is required: If you do not
include it, an error message is displayed and no tracing
is stopped.
LINKTRACE Conditionally required. Specifies that link-level
tracing is to be turned off.
You must specify at least one type of tracing; if you do
not, an error occurs.
NODETRACE Conditionally required. Specifies that SNA
Transport node tracing is to be turned off.
You must specify at least one type of tracing; if you do
not, an error occurs.
LUName Conditionally required. The name of the LU for
which SNA Transport intrinsic tracing is to be turned
off. The name can be up to eight alphanumeric
characters long; the first character must be alphabetic.
You must specify at least one type of tracing; if you do
not, an error occurs.