SNA Link/iX Node Managers Guide (30291-90009)

56 Chapter2
SNA Node and Link Configuration
Configuring the SNA Node and Link
Host Configuration: HP recommends that you use the
PU name (the SNA Node Name field in the SNA Node
Configuration screen) in this field.
AS/400 Configuration: For APPN, the RMTCPNAME in the
APPC display controller description must match this
field; see Table 2-10. Otherwise, HP recommends that
you use the PU name (the SNA Node Name field in the
SNA Node Configuration screen) in this field.
File
For display only. The name of the configuration file.
Once you have entered all of the PU information, press
[f6] (Save Data).
After the information is saved, if you need to configure
LU information, press [f2] (Go To LUDATA); this places
you at the “SNA Node Configuration: LU Data” screen
(described next in this chapter).
If you need to configure link information, press
[f1]
(Go To LINKDATA). If you specified SDLC for the Link
Type field on the “SNA Node Configuration: PU Data”
screen, you are placed at the “SNA Node Configuration:
SDLC Link Data” screen. If you specified X.25 for the
Link Type field, you are placed at the “SNA Node
Configuration: X.25 Link Data” screen. If you specified
TOKEN for the Link Type field, you are placed at the
“SNA Node Configuration: Token Ring Link Data”
screen. Each of the screens is described later in this
chapter.
If you do not need to configure LU information or link
information, press
[f8] (Prior Screen) until you get to
the screen you need next.
LU Data Screen
Once you have specified the PU information, you are ready to specify
LU information. You do this on the “SNA Node Configuration: LU Data”
screen as shown in Figure 2-5. Select this screen by pressing
[f2] (Go To
LUDATA) on the “SNA Node Configuration: PU Data” screen. (You can go
directly to this screen from any screen by typing
@SNANODE.
nodename .LUDATA in the command window and pressing
[ENTER].)