SNA Link/iX Node Managers Guide (30291-90009)

242 AppendixA
Messages
X.25 Link QLLC Internal Error Codes
X.25 Link QLLC Internal Error Codes
Listed below are the codes that are generated by the X.25 link Qualified
Logical Link Control (QLLC) module when a QLLC internal error
occurs. They are listed in numerical order according to the
ProcNum
displayed as part of these SNA Transport logging messages:
Link connect failure on node NodeName
subsystem = SubsysID , procedure = ProcNum , error num = ErrorNum
Link failure, recovery in progress on node NodeName
subsystem = SubsysID , procedure = ProcNum , error num = ErrorNum
Link failure, shutting down the node NodeName
subsystem = SubsysID , procedure = ProcNum , error num = ErrorNum
The logging messages are described in “SNA Transport Logging
Messages” earlier in this appendix. The X.25 link-related
ErrorNum
values are described in “X.25 Link Failure Error Codes” earlier in this
appendix.
-1 MESSAGE: NETIPC ERROR DETECTED
CAUSE: The QLLC module was informed of a socket error (SOCKERR)
by NETIPC.
ACTION: Note the socket error number and see the NS 3000/XL Error
Messages Reference Manual for socket error information.
-2 MESSAGE: AFT ERROR
CAUSE: The QLLC module encountered an error while trying to obtain
the available file table (AFT).
ACTION: Call your Hewlett-Packard support contact.
-3 MESSAGE: INSTALLATION ERROR
CAUSE: The SNA/X.25 Link IOWAIT completor is not installed on the
system.
ACTION: Call your Hewlett-Packard support contact.
-4 MESSAGE: QLLC PORT CREATION ERROR
CAUSE: The QLLC module encountered an error while trying to create
its IOWAIT port.
ACTION: Call your Hewlett-Packard support contact.
-5 MESSAGE: PORT SUBQUEUE ERROR
CAUSE: The QLLC module encountered an error while trying to enable
its IOWAIT port subqueues.
ACTION: Call your Hewlett-Packard support contact.