SNA Link/iX Node Managers Guide (30291-90009)

Appendix A 205
Messages
SNACONTROL Error Messages
SNACIERR 60 MESSAGE: CAN’T SPECIFY “LINK=A” HERE. (SNACIERR 60)
CAUSE: The
LINK=A parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=A .
ACTION: Reissue the command without a
LINK=A parameter.
SNACIERR 61 MESSAGE: CAN’T SPECIFY “LINK=C” HERE. (SNACIERR 61)
CAUSE: The
LINK=C parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=C .
ACTION: Reissue the command without a
LINK=C parameter.
SNACIERR 62 MESSAGE: CAN’T SPECIFY “LINK=L” HERE. (SNACIERR 62)
CAUSE: The
LINK=L parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=L .
ACTION: Reissue the command without a
LINK=L parameter.
SNACIERR 63 MESSAGE: CAN’T SPECIFY “LINK=S” HERE. (SNACIERR 63)
CAUSE: The
LINK=S parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=S .
ACTION: Reissue the command without a
LINK=S parameter.
SNACIERR 64 MESSAGE: CAN’T SPECIFY “LINK=D” HERE. (SNACIERR 64)
CAUSE: The
LINK=D parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=D .
ACTION: Reissue the command without a
LINK=D parameter.
SNACIERR 65 MESSAGE: CAN’T SPECIFY “LINK=R” HERE. (SNACIERR 65)
CAUSE: The
LINK=R parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
LINK=R .
ACTION: Reissue the command without a
LINK=R parameter.
SNACIERR 66 MESSAGE: CAN’T SPECIFY “LINK=ALL” HERE. (SNACIERR 66)
CAUSE: The
LINK=ALL parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL