SNA Link/iX Node Managers Guide (30291-90009)

202 AppendixA
Messages
SNACONTROL Error Messages
SNACIERR 36 MESSAGE: CAN’T SPECIFY STYPE HERE. (SNACIERR 36)
CAUSE: The
STYPE parameter was specified in an SNACONTROL
command; none of the commands uses STYPE.
ACTION: Reissue the command without an STYPE parameter.
SNACIERR 37 MESSAGE: CAN’T SPECIFY STOP TYPE HERE. (SNACIERR 37)
CAUSE: The
StopType parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STATUS, SNACONTROL
TRACEOFF, SNACONTROL TRACEON, or SNACONTROL VERSION command.
None of these commands uses
StopType .
ACTION: Reissue the command without a
StopType parameter.
SNACIERR 39 MESSAGE: CAN’T SPECIFY TRACE HERE. (SNACIERR 39)
CAUSE: The
TRACE parameter was specified in an SNACONTROL
command; none of the commands uses
TRACE .
ACTION: Reissue the command without a
TRACE parameter.
SNACIERR 41 MESSAGE: CAN’T SPECIFY ERROPT HERE. (SNACIERR 41)
CAUSE: The
ERROPT parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL STATUS, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
ERROPT .
ACTION: Reissue the command without an
ERROPT parameter.
SNACIERR 42 MESSAGE: CAN’T SPECIFY NCB HERE. (SNACIERR 42)
CAUSE: The
NCB parameter was specified in an SNACONTROL AUTODIAL,
SNACONTROL START, SNACONTROL STOP, SNACONTROL STOPSESS,
SNACONTROL TRACEOFF, SNACONTROL TRACEON,orSNACONTROL VERSION
command. None of these commands uses
NCB .
ACTION: Reissue the command without an
NCB parameter.
SNACIERR 43 MESSAGE: CAN’T SPECIFY HSCB HERE. (SNACIERR 43)
CAUSE: The
HSCB parameter was specified in an SNACONTROL AUTODIAL,
SNACONTROL START, SNACONTROL STOP, SNACONTROL STOPSESS,
SNACONTROL TRACEOFF, SNACONTROL TRACEON,orSNACONTROL VERSION
command. None of these commands uses
HSCB .
ACTION: Reissue the command without an
HSCB parameter.
SNACIERR 44 MESSAGE: CAN’T SPECIFY ROUTE HERE. (SNACIERR 44)
CAUSE: The
ROUTE parameter was specified in an SNACONTROL
AUTODIAL, SNACONTROL START, SNACONTROL STOP, SNACONTROL
STOPSESS, SNACONTROL TRACEOFF, SNACONTROL TRACEON, or
SNACONTROL VERSION command. None of these commands uses
ROUTE .
ACTION: Reissue the command without a
ROUTE parameter.