SNA Link/iX Node Managers Guide (30291-90009)
Table Of Contents
- 1 SNA Links Overview
- 2 SNA Node and Link Configuration
- 3 Logging Configuration
- 4 SNA Node Startup and Shutdown
- 5 SNA Link Troubleshooting
- 6 MPE Commands
- 7 SNA Link Installation Information
- A Messages
- SDLC Link Startup Error Messages
- SDLC Link Driver Error Messages
- SNACONTROL Error Messages
- SNA Transport Error Messages
- SNA Transport Logging Messages
- SDLC Link Shutdown Error Messages
- X.25 Link Failure Error Codes
- X.25 Link Module Configurator Error Codes
- X.25 Link QLLC Internal Error Codes
- NetView Alerts Error Messages
- Network Dump Manager Error Messages
- LAN Error Messages
- B Netview Alerts
196 AppendixA
Messages
SNACONTROL Error Messages
SNACONTROL Error Messages
Listed below are the error messages that can be returned by
SNACONTROL commands. They are listed in numerical order according to
message number. These messages are written to $STDLIST; they are
not logged.
NMS messages might also be returned in response to SNACONTROL
commands. For a list of those messages and their meanings, see the
Using the Node Management Services Utilities manual.
SNACIERR 1 MESSAGE: SNA COMMAND ESCAPE CODE: SUBSYS=
SubsysID
INFO=
ErrorNum
. (SNACIERR 1)
CAUSE: This message provides troubleshooting information. It is added
to many SNA command interpreter (CI) error messages and aids in
locating the possible source of a problem.
ACTION: None.
SNACIERR 2 MESSAGE: SNA TRANSPORT NOT PROPERLY INSTALLED. CHECK
VERSIONS. (SNACIERR 2)
CAUSE: A version check of SNA Transport failed because of differences
in module versions or because of missing modules.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNACIERR 3 MESSAGE: TRACE ALREADY IN PROGRESS FOR THIS ENTITY.
(SNACIERR 3)
CAUSE: The SNACONTROL TRACEON command was issued for an
LUName
or link that is already executing tracing.
ACTION: If you are turning on intrinsic tracing, ensure that you are
specifying the correct
LUName
in the SNACONTROL TRACEON command. If
you are, issue the SNACONTROL STATUS command to see whether tracing
is already on for that LU. If you are turning on link-level tracing,
ensure that you are specifying the
LINKTRACE
parameter in the
SNACONTROL TRACEON command.
SNACIERR 4 MESSAGE: TRACE NOT IN PROGRESS FOR THIS ENTITY.
(SNACIERR 4)
CAUSE: The SNACONTROL TRACEOFF command was issued for an
LUName
or link that is not executing tracing.
ACTION: If you are turning off intrinsic tracing, ensure that you are
specifying the correct
LUName
in the SNACONTROL TRACEOFF command.
If you are, issue the SNACONTROL STATUS command to see whether
tracing is already off for that LU. If you are turning off link-level