SNA Link/iX Node Managers Guide (30291-90009)

188 AppendixA
Messages
SDLC Link Driver Error Messages
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard support contact.
1045 MESSAGE: Unable to release an I/O Services message frame.
CAUSE: A call to the system message freeing routine returned in error.
The port might belong to a process that no longer exists or is not
operating with the required capabilities. Also, the message frame might
not have been recognized by the system as a valid message frame.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard support contact.
1046 MESSAGE: Attempt to find I/O Services message on port failed.
CAUSE: The system rejected an attempt by the driver to locate message
frames on its own port. Memory data corruption might have occurred.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard support contact.
1047 MESSAGE: Attempted impossible state after a request or completion.
CAUSE: The driver tried to enter a state that it should never be able to
get into, and ceased operations. Memory data corruption, a driver bug,
or a problem with the execution priorities of the driver or its hardware
might exist. The hardware might also be confused.
ACTION: This problem should produce a dump. Keep the dump along
with the error information displayed on the console, call your
Hewlett-Packard support contact, and submit an SR.
1048 MESSAGE: Driver notified of powerfail by system.
CAUSE: The driver was notified that power returned after a power
failure of any duration.
ACTION: The driver is not capable of recovering from power failures,
and modem connections were probably lost. Restart the link.
1049 MESSAGE: Request received when driver broken.
CAUSE: The driver had to reject a request message because it had
previously stopped working for another reason. The rejected request
cannot be processed while the driver is not working.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard support contact.
1050 MESSAGE: Request received when driver dead.
CAUSE: The driver received a request message during a short time
interval after shutdown completed, but before the driver’s port had
been destroyed by the system. The driver should not be receiving new
requests after shutdown, and it cannot successfully complete them.