SNA Link/iX Node Managers Guide (30291-90009)

Chapter 6 141
MPE Commands
SNACONTROL STATUS
ROUTE Specifies that the session’s Routing Table entry
(packets received) is to be displayed.
This parameter is for Hewlett-Packard debugging
purposes, and should be used only under HP
recommendation.
LURECORD Specifies that the session’s LU record is to be displayed.
This parameter is for Hewlett-Packard debugging
purposes, and should be used only under HP
recommendation.
LINK This is the same as specifying the ALL link status
parameter (described below).
ALL All of the status information for the link is displayed:
• Link state status (see the
LINKSTATE parameter
description)
• Link configuration data (see the CONFIGURATION
parameter description)
• Link statistics (see the
STATISTICS parameter
description)
Note that if no other link status parameter ( LINKSTATE ,
CONFIGURATION , STATISTICS , DIAGSTATS , and RESET )
is specified, this parameter (
ALL ) is the default.
LINKSTATE State status information for the link is displayed:
SDLC:
• Link name
• Link type
• Link state
X.25:
• Link name
• Link type
• Link state
• Tracing status
• Trace file name
Token Ring:
• Link name
• Link type
• Link state