Read Before Installing MPE/iX Release 7.0 Express 1 (30216-90327)

Chapter 2

Modem Connections on A- and N-Class

2 Modem Connections on A- and N-Class

The modem that is supported on the Remote console port on the N-Class and A-Class systems is the

MultiTech Model MT5634ZBA (HP part No: 0960-1074).

The physical connection is

The cable is connected to the 9 pin Remote Console Serial port on the coreI/O card. Connect the

modem to the system and to the phone line. Make sure the modem is connected to the AC power

and is turned on. There is a small switch on the side of the modem.

The following is the dialog to verify and conﬁgure the modem:

==============================================

GSP Host Name: <systemname>

GSP> CA

===================================

This command allows you to modify the local and remote modem serial port conﬁgurations. Current

conﬁguration settings:

Local Console Serial Port bit rate: 9600 bits/s

Local Console Serial Port Flow Control: Software

Local Console Serial Port Terminal Type: hpterm

Remote Console Serial Port Modem Protocol: CCITT

Remote Console Serial Port Modem bit rate: 19200 bits/s

Remote Console Serial Port Modem Flow Control: Software

Remote Console Serial Port Modem Transmit Configuration Strings: Enabled

Remote Console Serial Port Modem Presence: always connected

Do you want to modify the Local Console Serial Port settings? (Y/[N])

Do you want to modify the Remote Console Serial Port Modem settings? (Y/[N])

Modem

console

port

24542M

or cable that

comes with modem

N-Class/A-Class

Remote