Read Before Installing MPE/iX Release 7.0 Express 1 (30216-90327)

Chapter 2
Modem Connections on A- and N-Class
10
===================================
If the parameters are not correct for the Remote Console Serial port, then answer “Y” to the second
prompt. Here is the full dialog to change the configuration if needed:
Do you want to modify the Remote Console Serial Port Modem settings? (Y/[N])
y
y
Current Remote Console Serial Port Modem Protocol: CCITT
Do you want to modify it? (Y/[N]) y
y
Enter Modem Protocol (Bell / CCITT): c
c
New Modem Protocol: CCITT
Confirm? (Y/[N]): y
y
-> Modem Protocol will be updated.
Current Modem bit rate: 19200 bits/s
Do you want to modify it? (Y/[N]) y
y
Enter Modem bit rate (in bits/s): 19200
19200
New Modem bit rate: 19200 bits/s
Confirm? (Y/[N]): y
y
-> Modem bit rate will be updated.
Current Flow Control: Software
Do you want to modify it? (Y/[N]) y
y
Enter Flow Control (Hardware / Software): s
s
New Flow Control: Software
Confirm? (Y/[N]): y
y
-> Flow Control will be updated.
Transmit Configuration Strings: Enabled
Do you want to modify it? (Y/[N]) n
n