NS3000/iX Operations and Maintenance Reference Manual (36922-90042)

196 AppendixA
LINKCONTROL Command
NS 3000/iX FDDI Link Statistics
Receives lost — The number of frames received that had an error.
Receives not copied — The number of frames addressed to this
station but not copied into a receive buffer because there was no room
for them.
Receives discarded — The number of frames received by this station
that were discarded due to errors, invalid addresses, or lack of
resources.
ALL Parameter Fields
The ALL parameter for FDDI links displays a combination of all fields
presented by the LINKSTATE, CONFIGURATION, and STATISTICS
commands. Please reference the previous sections for descriptions of
the various fields.
DIAGNOSTIC Parameter Fields
The DIAGNOSTIC parameter for FDDI links displays all fields presented
by the ALL parameter plus several additional fields that might be useful
for HP representatives trying to debug FDDI link related problems.
Brief descriptions will be given here; however, please note that some
descriptions will be meaningful only to HP factory representatives. The
following is an example of the additional fields displayed by this
command.
Writes completed 0 Reads completed 0
Write bytes 0 Read bytes 0
Unicast writes 0 Unicast reads 0
Multicast writes 0 Multicast reads 0
Broadcast writes 0 Broadcast reads 0
Writes aborted 0 Reads aborted 0
Outbound high water 0 Non-routable reads 0
Num of heartbeats 3494 Subset buffer reqs 1
Number of users 1 Num of subset bufs 62
Num of power fails 0 Queued buffer reqs 0
Ring up time 3494 Read buffs in pool 63
Ring drops 0 Read buffs avail 49
Loquix reinits 0 Read buffer size 5312
SMT events 8
Lan_in_active ON
Configured ON
Ring_op ON
Reserved 1 0 Reserved 2 0
Reserved 3 0 Reserved 4 0
Writes completed — The number of data packets successfully sent
from the driver to the FDDI card. The maximum value is two billion
(2^31).