NS3000/iX Operations and Maintenance Reference Manual (36922-90042)

Chapter 7 137
Commands
NETCONTROL TRACEON and TRACEOFF
NET= niName
Specifies the name of a configured network interface
which is not a gatehalf. Enter any valid NI name, as
configured with NMMGR. Using this parameter, the
function applies only to the network interface itself, not
to any attached protocols.
GATE=
gatehalfName
Specifies the name of a configured gateway half
network interface to start tracing on. Enter any valid
gatehalf NI name from the NMMGR Network Interface
Configuration screen. If the specified gatehalf NI was
not previously configured and started, a “NOT
STARTED” error will occur.
PROT=
gprot PROT= niProt
Specifies that a protocol is the pertinent entity for each
specified function to act on. Enter the name of the
protocol, as follows:
gprot Specifies the name of one transport
general protocol to start tracing on.
Valid inputs are TCP, UDP, PXP, or
IPU. If the specified protocol did not
start or is not one of these inputs, a
“NOT ACTIVE” error will occur.
niprot Specifies the name of one network
interface protocol to start tracing on;
must be used in conjunction with the
NI=niname parameter. Valid inputs
depend on the NI type, as shown here.
If the specified protocol did not start, is
not configured, or is not one of these
inputs, a “NOT ACTIVE” error will
occur.