NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 6 81
Virtual Terminal (VT ERROR) Error Messages
16 MESSAGE: CR/LF SWITCH FAILED.
CAUSE: The File System did not honor the request to alter the issuing of
Line Feed on receipt of a Carriage Return.
ACTION: This may affect the actions of the remote application program:
if problems occur, reestablish the remote session.
17 MESSAGE: SET READ TIMEOUT FAILED.
CAUSE: Setting of a timed read failed.
ACTION: This may affect the actions of the remote application program:
if problems occur, reestablish the remote session.
18 MESSAGE: SET ECHO FAILED.
CAUSE: The echo setting was not altered as requested by the application
program.
ACTION: This will affect the remote program: terminate and rerun the
program.
19 MESSAGE: SET PRE/POST SPACE FAILED.
CAUSE: Space control was not altered.
ACTION: Line feeds will not be issued as requested: rerun the remote
program.
20 MESSAGE: PREEMPTIVE WRITE.
CAUSE: A preemptive write could not be issued.
ACTION: None.
21 MESSAGE: FWRITE TO TERMINAL FAILED.
CAUSE: Data could not be written to the terminal.
ACTION: Reconfigure the terminal to respond to the attached CPU.
22 MESSAGE: GET TERM-TYPE FAILED.
CAUSE: Terminal type could not be retrieved from the file system.
ACTION: Reattempt to establish the remote session. If it fails again,
make sure that the terminal is properly configured for MPE.
23 MESSAGE: SET EOR FAILED.
CAUSE: End-of-Record setting failed.
ACTION: Terminate the remote program, reset the terminal, and run
the program again.
24 MESSAGE: SET EDIT MODE FAILED.
CAUSE: The mode required by the remote program was not set by MPE.
ACTION: Terminate the remote program and attempt to rerun it.