NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 21 547
Logging Location Codes
Dial ID Logging Location Codes
Dial ID Logging Location Codes
1 CLAS0001 MESSAGE: None
CAUSE: A port message was received containing an invalid function
code (PARM = function code).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
2 CLAS0004 MESSAGE: None
CAUSE: Dial ID protocol started.
ACTION: Informational message.
3 CLAS0002 MESSAGE: None
CAUSE: The room allocated for the node name and path report is too
small (PARM = required number of bytes needed).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
4 CLAS0002 MESSAGE: None
CAUSE: The packet received was not a valid Dial ID message type. The
packet is discarded (PARM = message type of received packet).
ACTION: Enable data trace for the Dial ID protocol when this log
message is generated. See Appendix A , “Submitting a CR,” of this
manual.
5 CLAS0001 MESSAGE: None
CAUSE: The sending of a “dial” message to the Control Process using
DICTSEND failed (PARM = result code of DICTSEND call).
ACTION: See Appendix A , “Submitting a CR,” of this manual.
6 CLAS0004 MESSAGE: None
CAUSE: Dial ID protocol stopped.
ACTION: Informational message.
7 CLAS0004 MESSAGE: None
CAUSE: A port timer message was received with no matching request
(PARM = timer request ID).
ACTION: Informational message.
8 CLAS0003 MESSAGE: None
CAUSE: Retransmission has occurred (PARM = index of device over
which retransmission has occurred).
ACTION: Informational message.