NS3000/iX Error Messages Reference Manual (36923-90043)

536 Chapter21
Logging Location Codes
NS Configurator Logging Location Codes
and sending other messages to it, an error occurred while trying to send
an Information message (PARM = 32-bit status returned by the call to
send_msg).
ACTION: There may be a problem with the Ports subsystem of MPE or a
bug in the Module Configurator. See Appendix A , “Submitting a CR,” of
this manual.
11 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create a new NI or a new protocol
module for an existing NI, an error occurred while trying to create a
Port Data Area for the module (PARM = 32-bit status returned by the
call to create_object).
ACTION: There may be a problem with the Ports subsystem of MPE, or
the system may be low on memory. It is also possible bad data in the
NMCONFIG file has caused size calculations to overflow (see Control
Process error 654). Check memory usage and the NMCONFIG file, and
if necessary, see Appendix A , “Submitting a CR,” of this manual.
12 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create a process for a general
protocol module, an error occurred while trying to start the process
(PARM = 32-bit status returned by the call to createprocess).
ACTION: The program file (i.e., ICMPSERV.NET.SYS) may be missing or
inaccessible, or there may be a problem with the program or with the
Process Management or Loader subsystems of MPE. Check that the file
exists and if necessary, see Appendix A , “Submitting a CR,” of this
manual.
15 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create an address resolution
protocol module for an existing NI, an error occurred while trying to
obtain the station address of the hardware interface card used by that
NI (PARM = 32-bit status returned by the call to
lan_8023_station_address).
ACTION: There may be an I/O configuration problem, a Link Services
problem, or a problem with the driver or its hardware. Check the
configuration and the hardware and if necessary, see Appendix A ,
“Submitting a CR,” of this manual.
16 CLAS0002 MESSAGE: INTERNAL ERROR; Internal resource error
CAUSE: When NETCP attempted to create a new protocol module for an
existing NI, an error occurred while trying to read the pool ID for that
modules message port (PARM = 32-bit status returned by the call to
xp_get_pool_id).
ACTION: There may be a problem with the port_info call into the Ports
subsystem of MPE. See Appendix A , “Submitting a CR,” of this