NetBase for MPE Reference Guide

Appendix B
B-22
AutoRPM Facility Detected Errors
The following NetBase errors are detected by the AutoRPM facility.
ERR# Error Message Explanation/Action
1301
NOT ENOUGH STACK SPACE TO
EXECUTE REMOTE PROCESS
Insufficient stack space is available to create
the remote process. Increase the MAXDATA for
the local program.
1302
CANNOT EXECUTE REMOTE
NETBASE PROCESS
NetBase internal error. If this error occurs
contact Quest Software.
1303
CANNOT EXECUTE LOCAL
NETBASE PROCESS
NetBase internal error. If this error occurs
contact Quest Software.
1304
REMOTE PROCESS HANDLING
NOT INSTALLED ON LOCAL
COMPUTER
Remote process handling is not installed on
the local computer.
1305
REMOTE PROCESS HANDLING
NOT INSTALLED ON REMOTE
COMPUTER
Remote process handing is not installed on
the remote computer.
1306
UNABLE TO CREATE REMOTE
PROCESS
NetBase was not able to create the process on
the remote computer. Check the PROGRAM
directory entry and make sure that the process
exists on the remote machine.
1307
NO RESPONSE FROM REMOTE
COMPUTER
This problem may occur if the machine is
heavily loaded or may be due to an internal
error.
1308
NO LOGON INFORMATION
SPECIFIED WITH DSLINE
COMMAND
Check the LOGON directory entry for the user.
1309
REMOTE HELLO FAILED
This error may be due to an incorrect logon
record in the directory or to an internal error.
1310
UNABLE TO CREATE TEMPORARY
ENVIRONMENT
NetBase internal error. If this error occurs
contact Quest Software.
1311
UNABLE TO CREATE LOCAL
STUB PROCESS
NetBase internal error. If this error occurs
contact QUEST Software.
Continued