NetBase for MPE Reference Guide

Installation/Update Procedures for NetBase
A-7
SHADOW - Post Inactivity Timeout... [0]
SHADOW - Enable Post Logging....... [N]
SHADOW - Log all Post Transactions. [N]
SHADOW - Save Process Info on Post. [N]
SHADOW - Abort Post on Errors...... [N]
SHADOW - Buffered Exporting........ [Y]
SHADOW - Transfer mode only........ [N]
SHADOW - Transfer Single Queues.... [N]
SHADOW - Transfer ACK Frequency.... [0]
SHADOW - Post Directory Filename... [DEFAULT]
This procedure is repeated for each system in the network to be accessed by NetBase.
The LIST command can be used to display the configured nodes.
_____ 2.3 Check the configuration using the LIST NODES command in CONFIG.
C> LIST NODES
Node Sys name Line Type Startup Spool Shadow
3* FOX N A N N
4 VIXEN N A B B
Currently 2 Nodes are defined
The * designates the local node.
Step 3: Install the NetBase Shell
Note. After the installation of the shell has been completed, the system must be
shutdown and restarted.
Global installation of NetBase requires that NetBase modules be installed into the system libraries
located in PUB.SYS. These libraries are SL.PUB.SYS, RTMSL.PUB.SYS and XL.PUB.SYS. Before
performing any installations to a system library, you should perform a complete backup of all
important data. In addition, you should have a current SLT prior to the install. The system should
be quiet, this means no active jobs or sessions, during the installation.
Global installation is accomplished via NBINST.PUB.NETBASE, an auto-installation program. This
installation program requires the user to be MANAGER.SYS. NBINST is run with an INFO string
depending on the product(s) being installed.