NetBase for MPE Reference Guide

Using CONFIG
3-27
Node Name
This is the NS node name of the specified node. It should be fully qualified if its domain and
organization differ from the local node.
Default = none Required Parameter
Node Connection Time-out
When a communication line is down, NetBase will check periodically to see if the line has come up.
Once the link between two nodes has been established, NetBase will further check the link if the
link has not been used for a set period. This value sets the time-out interval (in seconds) for these
two operations.
Default = 180
Minimum = 30
Maximum = 600
SPOOL - Direction (N/E/I/B)
This parameter describes the direction that spool files are to be transported relative to this node.
Valid values are:
Value Description
N
None.
E
Export to this node from the local node only.
I
Import from this node to the local node only.
B
Both import and export from this node to the local node.
When defining the local node, this parameter will be set to N. (If this node has been defined as the
local node via the GLOBAL parm, the spooling parms are not displayed.)
Default = N
SPOOL - Allow incoming job streams
This parameter allows users on the specified node to move input spool files (i.e. job streams) to the
local computer without establishing a remote session. The remote user must have OP capability to
execute this command. Setting this parameter to Y may cause a breach in security.
Default = N