MPE/iX System Utilities Reference Manual (32650-90908)

UPSUTIL for MPE/iX
UPSUTIL Commands
Chapter 32
266
End STOP UPS Monitor operation
--------------------------------------------------------------------
UPSUTIL: Command >
Example #2 — Rejected STOP
--------------------------------------------------------------------
UPSUTIL: Command > stop
--------------------------------------------------------------------
Begin STOP UPS Monitor operation
** WARNING: UPS Monitor process is not running at this time.
** WARNING: STOP UPS Monitor operation not performed.
End STOP UPS Monitor operation
--------------------------------------------------------------------
UPSUTIL: Command >
RESTART Command
The RESTART command is a shortcut method of stopping and then restarting the UPS Monitor Process. It is
equivalent to issuing a STOP command immediately followed by a START command.
Like the STOP command, the RESTART command will be rejected if the UPS Monitor Process is not
running at the time the RESTART command is issued.
The first example below shows a normal, successful execution of the RESTART command, while the second
example shows the results when the RESTART command is rejected because the UPS Monitor Process was
not running when the RESTART command was given.
Before issuing the RESTART command, you can use the STATUS command to verify that the UPS Monitor
Process is running.
After executing the RESTART command, you can use the STATUS command to verify that the RESTART
command worked. The STATUS command should reveal that the UPS Monitor Process is again running,
after shutting itself down and then relaunching itself.
Syntax
restart
Example #1 — Normal RESTART
--------------------------------------------------------------------
UPSUTIL: Command > restart
--------------------------------------------------------------------
Begin RESTART UPS Monitor operation