MPE/iX Intrinsics Reference Manual (32650-90905)

606 Chapter10
Command Definitions (QUIT-ZSIZE)
SETJCW
SETJCW
NM and CM callable.
Sets bits in the system job control word (JCW).
Syntax
U16V
SETJCW(
jcword );
Parameters
jcword 16-bit unsigned integer by value (required)
The user-defined bit contents of the system JCW for interprocess
communication.
Bits Value/Meaning
0:1 Reserved for the operating system
If (0:1)=1, the system outputs the following message when
the program terminates, either normally or due to an
error:
PROGRAM TERMINATED IN ERROR STATE
(CIERR 976)
In batch mode, the job is terminated unless the CONTINUE
command is used. If JCW is set to exactly %140000 (bits
(0:1)=1 and (1:1)=1 only), the CIERR 976 message is
replaced by:
PROGRAM ABORTED PER USER REQUEST
(CIERR 989)
1:15 Used for any purpose.
Related Information
Intrinsics FINDJCW, GETJCW, PUTJCW
Commands SETJCW, SHOWJCW
Manuals Interprocess Communication Programmer's Guide, Command Interpreter
Access and Variables Programmer's Guide, and MPE/iX Commands
Reference Manual.