MPE/iX Intrinsics Reference Manual (32650-90905)

222 Chapter6
Command Definitions (FLUSHLOG-GETUSERMODE)
FLUSHLOG
FLUSHLOG
NM and CM callable.
Flushes the contents of the user logging memory buffer to the user logging file. User
logging (LG) or system supervisor (OP) capability is required.
Syntax
I32 I16
FLUSHLOG(
index,logstatus );
Parameters
index 32-bit signed integer by reference (required)
Passes the access to the user logging system. This is the value returned in
the
index parameter of the OPENLOG intrinsic.
logstatus 16-bit signed integer by reference (required)
Returns one of the following values, indicating the success/failure of the
intrinsic call:
Value Meaning
0 Successful
4
Incorrect index parameter passed
7 Illegal capability; user logging (LG) or system supervisor (OP)
capability required
9 Error occurred while writing
12 System is out of disk space, user logging cannot proceed
14 Invalid access
15 End-of-file encountered
Operation Notes
The FLUSHLOG intrinsic writes the contents of the user logging memory buffer to the disk
destination file. This helps to preserve the contents of the memory buffer in the event of a
system failure. This intrinsic does not write special records.
Related Information
Manuals User Logging Programmer's Guide (32650-90027)