MPE/iX Intrinsics Reference Manual (32650-90905)
160 Chapter5
Command Deļ¬nitions (FCONTROL - FLOCK)
FDEVICECONTROL
next read only.
0
Disable the request.
This request is valid only if typeahead is enabled.
If issued against a terminal connected through PAD, CCE
(2) is returned, but the device control action does not occur.
62 Quiesce I/O: Valid values are:
1
The control will not complete until all previous I/O to the
device has completed. If issued against a terminal
connected through a PAD, control issues only previous I/O
sent to PAD and not to the device.
63 Single echo mode in typeahead: Valid values are:
1
Enables single echo. Typeahead data will be echoed only
when the read is posted.
0
Disable the request. Typeahead data will be echoed when
entered and when the read is posted (default mode).
This request is valid only if typeahead is enabled.
If issued against a terminal connected through PAD, CCE
(2) is returned, but the device control action does not occur.
64 Ignore parity error on input: Valid values are:
1
Parity errors will be ignored.
0
Parity errors will be reported (default).
If issued against a terminal connected through PAD, CCE
(2) is returned, but the device control action does not occur.
65
Interbyte Timer: Valid values are:
.1-255
Non zero values activate the Interbyte Timer in tenths of a
second granularity. Therefore, setting the value to 255 results
in an Interbyte Timer of 25.5 seconds. Once the timer is set, all
the following reads use the given Interbyte Timer value until
the timer is deactivated.
0
Disable the Interbyte Timer.