MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 1 39

Error Messages

Distributed Terminal Subsystems

Too many nodes are being used (max. number

allowed = 33). (DTSERR=19)

CAUSE The DTC speciﬁed in the NMMGRpath cannot be

processed. Too many nodes are being used.

ACTION Go to the DTC SELECTION screen and delete the DTC

speciﬁed in the NMMGRpath.

20 MESSAGE Path: NMMGRpath

Too many classes are being used (max. number

allowed = 450). (DTSERR=20)

CAUSE The total number of classes exceeds the maximum allowed

number.

ACTION Delete class names so that no more than 450 different

class names are associated with asynchronous devices.

21 MESSAGE Path: NMMGRpath

Too many profiles are being used (max. number

allowed = 100). (DTSERR=21)

CAUSE The total number of deﬁned proﬁles exceeds the maximum

allowed.

ACTION Delete proﬁles so that no more than 100 are speciﬁed.

22 MESSAGE No link is defined. (DTSWARN=22)

CAUSE A link is not conﬁgured.

ACTION Without a conﬁgured link, the network management

conﬁguration ﬁle is useless. Return to the conﬁguration

screens and add a link, making sure that all necessary

data records are created.

23 MESSAGE No DTC is defined. (DTSWARN=23)

CAUSE A DTC is not conﬁgured.

ACTION An action is not required if neither terminals, printers, nor

both are needed. If terminals and printers are required,

return to the conﬁguration screens and add a DTC,

making sure that all necessary data records are created.

24 MESSAGE Path: NMMGRpath

LINK.linkname is shared with network interface.

(DTSWARN=24)

CAUSE The same link is shared between the DTS and the NS

subsystem. A separate link must exist for each of the two

subsystems.

ACTION Decide which of the two subsystems should use the

existing link and conﬁgure an additional link for the

remaining subsystem.