MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 7 305
TurboIMAGE/XL V iii C 5
Utility Error Messages
2 –
data file block
3 –
data file end
4 –
tape end
ACTION An error for a known value that was written to tape with
FWRITE was found. There may be a defect in the tape or
the tape drive.
97 MESSAGE ZSIZE ERROR WHILE CONTRACTING AT xxxxx
CAUSE A TurboIMAGE utility called ZSIZE to contract the Z to
DB area of the stack. xxxxx is the octal location where
TurboIMAGE failed.
ACTION Notify HP Support Representative.
98 MESSAGE ZSIZE ERROR WHILE EXPANDING AT xxxxx
CAUSE A TurboIMAGE utility called ZSIZE to expand the Z to DB
area of the stack. xxxxx is the octal location where
TurboIMAGE failed.
ACTION Notify HP Support Representative.
101 MESSAGE DBRESTOR FAILURE IN DBRESTOR AT xxxxx
CAUSE The DBRESTOR utility called MPE/iX RESTORE which
encountered problems while restoring the database. A
detailed error message should follow this message.
ACTION Take appropriate action depending on the detail message.
401 MESSAGE DBOPEN FAILURE AT xxxxx
CAUSE A detailed error message can be retrieved by calling
DBEXPLAIN.
ACTION For more information "Library Procedure Error Messages"
earlier in this chapter.
402 MESSAGE DBINFO FAILURE AT xxxxx
CAUSE A detailed error message can be retrieved by calling
DBEXPLAIN.
ACTION For more information "Library Procedure Error Messages"
earlier in this chapter.
403 MESSAGE DBCLOSE FAILURE AT xxxxx
CAUSE A detailed error message can be retrieved by calling
DBEXPLAIN.
ACTION For more information "Library Procedure Error Messages"