MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 6 257
TurboIMAGE/XL V iii C 5
Library Procedure Error Messages
NOTE Return statuses 100 through 107 are communication errors. For 100 through
102, the third element of calling program's status area is the MPE/IX failure
code returned by DSCHECK intrinsics.
-100 MESSAGE DSOPEN failure
CAUSE While executing a DBOPEN, TurboIMAGE/XL has
encountered a hardware failure trying to obtain a
communications line.
ACTION Try opening the database again. If error persists, contact
your HP Support Representative.
-101 MESSAGE DSCLOSE failure
CAUSE This is an exceptional error returned by DBOPEN or
DBCLOSE. It indicates a hardware or system software
failure.
ACTION Notify system manager of problem.
-102 MESSAGE DSWRITE failure
CAUSE A line failure has occurred while attempting an operation
on a remote database. May be returned by DBOPEN,
DBFIND, DBGET, DBPUT, DBUPDATE, DBDELETE,
DBLOCK, DBUNLOCK, DBINFO, or DBCLOSE.
ACTION Try calling the procedure again. If error persists, notify
system manager.
-103 MESSAGE Remote 3000 stack too small
CAUSE Command Interpreter on remote HP 3000 cannot obtain
stack space necessary to execute a DBOPEN or DBLOCK.
ACTION Ask system manager of remote system to increase
available stack size.
-104 MESSAGE Remote 3000 does not support TurboIMAGE/XL
CAUSE This is an exceptional error and is returned by DBOPEN
on the remote system.
ACTION Notify system manager of problem.
-105 MESSAGE Remote 3000 cannot create TurboIMAGE control
block.
CAUSE This is an exceptional error and is returned by DBOPEN
on the remote system.
ACTION Notify system manager of problem.
-106 MESSAGE Remote 3000 data inconsistent
CAUSE This is an exceptional error returned by same intrinsics as
102 (see message listed earlier in this chapter). It