MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 1 11

Error Messages

CIPER Devices

(CIPER)

1 MESSAGE Ldev #\ not ready; check cable connections.

(CIPER 1)

2 MESSAGE Ldev #\ has been powered up or reset. (CIPER

3 MESSAGE Ldev #\ has been placed off-line. (CIPER 3)

4 MESSAGE Ldev #\ has been placed on-line. (CIPER 4)

5 MESSAGE Ldev #\ reports out of paper; please check

and correct if necessary. (CIPER 5)

6 MESSAGE Ldev #\ reports paper jam; please check and

correct if necessary. (CIPER 6)

7 MESSAGE Ldev #\ reports platen open; please check and

correct if necessary. (CIPER 7)

8 MESSAGE Ldev #\ reports ribbon error; please check

and correct if necessary. (CIPER 8)

9 MESSAGE Ldev #\ experienced self-test failure.

Failure code = !. (CIPER 9)

10 MESSAGE Ldev #\ reports protocol error: illegal

header length received. (CIPER 10)

11 MESSAGE Ldev #\ reports protocol error: record

sequence error in record received. (CIPER 11)

12 MESSAGE Ldev #\ reports protocol error: incorrect

creator of record received. (CIPER 12)

13 MESSAGE Ldev #\ reports protocol error: undefined

command received. (CIPER 13)

14 MESSAGE Ldev #\ reports protocol error: undefined

data type received. (CIPER 14)

15 MESSAGE Ldev #\ reports protocol error: illegal

format number in environmental status block.

(CIPER 15)

17 MESSAGE Ldev #\ reports protocol error: illegal block

label length received. (CIPER 17)

18 MESSAGE Ldev #\ reports protocol error: transport

service error. (CIPER 18)

19 MESSAGE Ldev #\ reports protocol error: data overrun

from host. (CIPER 19)