MPE/iX Error Messages Manual Vol 2 (32650-90902)

416 Chapter10
Store/Restore (Native Mode) and TurboSTORE/iX I
(S/R)
405 MESSAGE INVALID VOLUME NAME SPECIFIED FOR 'VOL'
OPTION. VOLUME NAME MUST
START WITH AN ALPHA "A-Z" AND CONTAIN ONLY
ALPHANUMERIC
"A-Z, 0-9", OR "_". SYNTAX
'VOL=volumename' (S/R 405)
CAUSE Volume name misspelled or unrecognizable volume name
was entered.
ACTION Enter the correct volume name.
406 MESSAGE VOLUME NAME SPECIFIED FOR 'VOL' OPTION
EXCEEDED THE MAXIMUM
ALLOWABLE LENGTH OF 16 CHARACTERS. SYNTAX
'VOL=volumename' (S/R 406)
CAUSE The volume name you specified is too long. The maximum
number of chharacters is 16.
ACTION Specify a volume name with 16 or fewer characters.
407 MESSAGE EXPECTED 'volumename' AFTER 'VOL=' WHERE
volumename IS THE NAME
OF A VOLUME (DISC) THAT IS CURRENTLY MOUNTED
ON YOUR SYSTEM. SYNTAX
'VOLSET=volumesetname' (S/R 407)
CAUSE You did not enter the volumename.
ACTION Check the syntax and retype the command.
408 MESSAGE 'VOL' OPTION CANNOT BE USED WITH THE
'LISTDIR' OPTION (S/R 408)
CAUSE Vol and listdir options are not allowed on the same
command line.
ACTION Delete either vol or listdir option and retype the command.
411 MESSAGE WARNING: 'HIGH' OPTION HAS BEEN REDUNDANTLY
SPECIFIED (S/R 411)
CAUSE The HIGH option was entered more than once.
ACTION Information only.
412 MESSAGE EXPECTED '={datasetnumber}' AFTER 'HIGH'
OPTION. SYNTAX
'HIGH={datasetnumber}' (S/R 412)
CAUSE You did not specify datasetnumber.
ACTION Check the syntax and retype the command.