MPE/iX Error Messages Manual Vol 2 (32650-90902)

40 Chapter1
Vol. II Chapter 1
Loader, Native Mode
FILE TABLE. (LDRERR 612)
CAUSE The file requested by the linker to unlock a SOM is not
loaded.
ACTION Retry. If this is unsuccessful, call your Hewlett-Packard
Representative.
613 MESSAGE The file was not mapped to offset 0 (user
labels not allowed in programs). (LDRERR 613)
CAUSE User labels were found in the program file.
ACTION Rebuild the file.
614 MESSAGE The max SOM limit in the file exceeds the
maximum of 5000 allowed by LOADER. (LDRERR
614)
CAUSE The library file specified has too large of the maximum
number of SOMs.
ACTION Rebuild the file with fewer SOMs.
616 MESSAGE Failed to get an entry for a process file
extension record. (LDRERR 616)
CAUSE Failed to allocate an entry for the process file list
extension.
ACTION Retry. If this is unsuccessful, call your Hewlett-Packard
Representative.
617 MESSAGE LOADER internal error; past end of binding
sequence. (LDRERR 617)
CAUSE Internal error. Attempt to read past the end of the process
file list.
ACTION Retry. If this is unsuccessful, call your Hewlett-Packard
Representative.
618 MESSAGE Failed to release the PROCESS FILE LIST
TABLE. (LDRERR 618)
CAUSE An error occurred while releasing the PROCESS FILE
LIST TABLE.
ACTION Retry. If this is unsuccessful, call your Hewlett-Packard
Representative.
650 MESSAGE NM UNLOADER failed. (LDRERR 650)
CAUSE An error occurred while unloading the process.
ACTION Retry. If this is unsuccessful, call your Hewlett-Packard
Representative.
651 MESSAGE CM UNLOADER returned an error. (LDRERR 651)
CAUSE An error occurred while unloading the COMPATIBILITY