MPE/iX Error Messages Manual Vol 2 (32650-90902)

Chapter 9 349
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
CAUSE The referenced path has been improperly entered.
SYSGEN requires periods as separators in the path
definition to be able to check the components in the path.
ACTION Reenter the path specification.
1101 MESSAGE **error** path ! ends in a period
CAUSE The referenced path is incomplete and ends in a period, or
has an extra period.
ACTION Reenter the path for the operation.
1102 MESSAGE **error** path ! has a bad component
(too large, or non-numeric)
CAUSE The iopath that you entered contains an alphabetic or
special symbol, a number that is too large, or some other
entry that cannot be recognized.
ACTION Reenter the path.
1103 MESSAGE **error** path name too long
CAUSE The path you have entered has too many levels.
ACTION Reenter the path.
1104 MESSAGE **error** path ! already exists.
CAUSE You are trying to add a path or device that already exists.
ACTION Use the LPATH command and necessary level to list the
existing paths. If necessary, use the LDEV command to list
associated devices.
1105 MESSAGE **error** mode 'NONE' can't be used with
other modes
CAUSE The device mode NONE cannot be used with other modes
when more than one mode is assigned to a device.
ACTION Either add or modify the device and assign NONE as the
only mode or enter the proper modes.
1106 MESSAGE **error** % permanent + % transient must be
at lease 100 percent
CAUSE The total amount of permanent and transient space
assigned to a volume must be at least 100 percent.
ACTION Increase either the transient or permanent percentage
until the sum is 100 percent.
1107 MESSAGE **error** Class name ! is too long.
CAUSE The class name entered exceeds either characters.
ACTION Reduce the number of characters in the class name.
1109 MESSAGE **warning** SYSGEN and NMMGR configuration