MPE/iX Error Messages Manual Vol 2 (32650-90902)

328 Chapter9
System Startup, Shutdown, and Configuration (cont)
Class Errors
CAUSE The system ID in the file header is invalid.
ACTION See NOTE at the end of the ISL error messages.
CE17 MESSAGE Error reading utility file header. (E)
CAUSE Firmware, hardware, or device error is possible.
ACTION Update the system from the system boot tape. Retry. If
failure recurs, contact your Hewlett-Packard Support
Representative.
CE18 MESSAGE Utility file header inconsistent: Bad magic
number. (W)
CAUSE ISL cannot read file header information.
ACTION See NOTE at the end of the ISL error messages.
CE19 MESSAGE Utility would overlay ISL in memory. (W)
CAUSE Utility is too large, load address is too low in memory to be
read in without overlaying ISL memory area.
ACTION See NOTE at the end of the ISL error messages.
CE1A MESSAGE Utility requires more memory than is
configured. (W)
CAUSE Utility requires more memory than exists and is available
for execution.
ACTION Add more memory to the system and reboot, or boot a
different utility.
CE1B MESSAGE Error reading utility into memory. (E)
CAUSE Firmware, hardware, or device error is possible.
ACTION Contact your Hewlett-Packard Support Representative.
CE1C MESSAGE Incorrect checksum - reading utility into
memory. (W)
CAUSE The utility is corrupted.
ACTION Replace the utility from the master backup, or execute a
different utility. See NOTE at the end of the ISL error
messages.
CE1D MESSAGE System console needed - FATAL! (E)
CAUSE No system console exists or is enabled for required
operation.
ACTION Attach a system console or enable a remote console as the
master console, and reset the system.
CE21 MESSAGE Destination memory address of utility is
invalid. (E)
CAUSE Utility is corrupted.