MPE/iX Error Messages Manual Vol 2 (32650-90902)

320 Chapter9
System Startup, Shutdown, and Configuration (cont)
Class Errors
003E MESSAGE No message. System halts. (E)
CAUSE A nonrecoverable taken branch or break trap occurs.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
003F MESSAGE No message. System halts. (E)
CAUSE A bad instruction is received from RDB.
ACTION Contact your Hewlett-Packard Support Representative.
0040 MESSAGE No message. System halts. (E)
CAUSE A configured module is lost on powerfail.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
0041 MESSAGE No message. System halts. (E)
CAUSE A bus converter is lost on powerfail.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
0042 MESSAGE No message. System halts. (E)
CAUSE A bus converter was added on powerfail.
ACTION Contact your Hewlett-Packard Support Representative.
0043 MESSAGE No message. System halts. (E)
CAUSE memory was added on powerfail.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
0044 MESSAGE No message. System halts. (E)
CAUSE A module was added on powerfail and it generated an
address conflict.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
0045 MESSAGE No message. System halts. (E)
CAUSE Memory self-test fails in map_system_state.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
0046 thru 004E MESSAGE No message. System halts. (E)
CAUSE Error occurs on call to entry_init in reinit_iodc.
ACTION Contact your Hewlett-Packard Support Representative.
005B thru 005F MESSAGE No message. System halts. (E)
CAUSE The parallel card driver (RDB communications)