Manualshelf

MPE/iX Error Messages Manual Vol 2 (32650-90902)

ManualsBrandsHP ManualsSoftwareMPE/iX 7.5 Operating System
311312313314315316317318319320
Chapter 9 319
System Startup, Shutdown, and Configuration (cont)
Class Errors
Hewlett-Packard Support Representative and boot from
the system disk.
Class Error B: Initialization Messages
When the system halts, the reason for the halt can be seen on the SPU control panel status
display (hex display). The first number is the source of the halt call, and following it are
numbers of the form 0nxx where n is a number that starts at 1 and increments. The
reason can be interpreted by stringing the xx values together to form a number.
When the monitor is the source of the halt, the first number is B000. System abort uses
B007. The following codes relate the cause of the error.
0001 thru 0019 MESSAGE No message. System halts. (E)
CAUSE The break handler (to RDB) was reentered.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
0020 MESSAGE No message. System halts. (E)
CAUSE A break zero (0) instruction is encountered without RDB.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
0021 MESSAGE No message. System halts. (E)
CAUSE An unknown high priority machine check occurs.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
0022 MESSAGE No message. System halts. (E)
CAUSE A nonrecoverable low priority machine check occurs.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
0028 MESSAGE No message. System halts. (E)
CAUSE Reinit_iodc fails to read entry_init.
ACTION Contact your Hewlett-Packard Support Representative.
0029 MESSAGE No message. System halts. (E)
CAUSE Reinit_iodc fails to read entry_io.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.
0030 MESSAGE No message. System halts. (E)
CAUSE Image does not fit the first memory controller.
ACTION Try rebooting the system. If error recurs, contact your
Hewlett-Packard Support Representative.