MPE/iX Error Messages Manual Vol 2 (32650-90902)

314 Chapter8
System Startup, Shutdown, and Configuration
Class Errors
45 MESSAGE No message. System halts. (E)
CAUSE Subchannel is not readied after attention request enable
followed by an attention request operation.
ACTION Contact your Hewlett-Packard Support Representative.
46 MESSAGE No message. System halts. (E)
CAUSE I/O card returns wrong status after an attention request.
ACTION Contact your Hewlett-Packard Support Representative.
47 MESSAGE No message. System halts. (E)
CAUSE Correct bit is not set in the attention request register.
ACTION Contact your Hewlett-Packard Support Representative.
48 MESSAGE No message. System halts. (E)
CAUSE Attention request bit set prior to attention request test.
(Error unknown.)
ACTION Contact your Hewlett-Packard Support Representative.
49 MESSAGE No message. System halts. (E)
CAUSE Subchannel does not request attention after enabling
attention request and request attention. (write control of
ARE and RQA.)
ACTION Contact your Hewlett-Packard Support Representative.
4F MESSAGE No message. Self-test continues. (W)
CAUSE Channel cannot complete its test without a
Hewlett-Packard IB card.
ACTION check device adapters. Contact your Hewlett-Packard
Support Representative if device problems occur.
50 MESSAGE No message. System halts. (E)
CAUSE Cannot verify I/O test checksum.
ACTION Contact your Hewlett-Packard Support Representative.
Class Error 9: Console Path Test
Class Error 9
Console path related errors and/or channel I/O errors take the following multiplexed code
form:
01wx
9yzz
where:
w = CIO slot number (<> C)