MPE/iX Error Messages Manual Vol 2 (32650-90902)

Chapter 8 311
System Startup, Shutdown, and Configuration
Class Errors
ACTION Contact your Hewlett-Packard Support Representative.
13 MESSAGE No message. System halts. (E)
CAUSE Chain command does not clear the RDY bit.
ACTION Contact your Hewlett-Packard Support Representative.
14 MESSAGE No message. System halts. (E)
CAUSE Cannot get an interrupt at the end of DMA. (Appropriate
bit in submask register not set.)
ACTION Contact your Hewlett-Packard Support Representative.
15 MESSAGE No message. System halts. (E)
CAUSE DMA does not transfer data.
ACTION Contact your Hewlett-Packard Support Representative.
16 MESSAGE No message. System halts. (E)
CAUSE RDY bit is not set at the end of DMA.
ACTION Contact your Hewlett-Packard Support Representative.
17 MESSAGE No message. System halts. (E)
CAUSE CIO card returns wrong status after the subchannel is
disconnected.
ACTION Contact your Hewlett-Packard Support Representative.
18 MESSAGE No message. System halts. (E)
CAUSE Undefined error occurs with a CIO card. RFC, PST, PRE,
or LVI do not match.
ACTION Contact your Hewlett-Packard Support Representative.
1A MESSAGE No message. System halts. (E)
CAUSE Hewlett-Packard IB loopback test reports data write
status error.
ACTION Contact your Hewlett-Packard Support Representative.
1B MESSAGE No message. System halts. (E)
CAUSE Hewlett-Packard IB cannot get ready for command.
ACTION Contact your Hewlett-Packard Support Representative.
1C MESSAGE No message. System halts. (E)
CAUSE Hewlett-Packard IB loopback test reports undefined
status error.
ACTION Contact your Hewlett-Packard Support Representative.
1D MESSAGE No message. System halts. (E)
CAUSE Hewlett-Packard IB loopback test reports data error.