MPE/iX Error Messages Manual Vol 2 (32650-90902)

166 Chapter5
Volume II Chapter 4
System Aborts
storage map was updated. This is currently a
bug catcher, but may become permanent.
2036 MESSAGE VALIDATE_SEC_STORAGE - This is a bad LDEV
parameter.
2037 MESSAGE VALIDATE_SEC_STORAGE - This is a bad
DISC_ADDRESS parameter.
2038 MESSAGE VALIDATE_SEC_STORAGE - The parameter number
of bytes is less than zero.
2039 MESSAGE VALIDATE_SEC_STORAGE - The ending page to be
validated exceeded the last page of the
device.
2040 MESSAGE VALIDATE_SEC_STORAGE - The number of byte MOD
PAGE_SIZE is not zero.
2041 MESSAGE VALIDATE_SEC_STORAGE - The page being
validated was not a permanent page.
2042 MESSAGE VALIDATE_SEC_STORAGE - A trap occurred during
VALIDATE_SEC_STORAGE.
2043 MESSAGE SSM_REPLAY_LOG - A trap occurred while XM was
recovering the SSM MAP.
2044 MESSAGE DISMOUNT_SSM_DEVICE - A trap occurred during
DISMOUNT_SSM_DEVICE.
2045 MESSAGE SSM_VERIFY_MAPS_FOR_MOUNTED_SYS_VOLS page
counts in map header does not match the bit
map count.
2046 MESSAGE SSM_SA_VERIFY_ENTIRE_MAP - An error was
received from PREFETCH in
SSM_SA_VERIFY_ENTRE_MAP.
2047 MESSAGE SSM_SA_INIT_SSM_GLOBAL_AREA - CB_INIT failed.
2048 MESSAGE SSM_SA_INIT_SSM_GLOBAL_AREA - CREATE_OBJECT
failed.
2049 MESSAGE SSM_SA_UPDATE_SEC_STORAGE_MAP - VERIFY_MAP
failed.
2050 MESSAGE UPDATE_SEC_STORAGE_MAP - One of the page
counters went negative before the SECONDARY
STORAGE MAP was updated. This is currently a
bug catcher, but may become permanent.
2051 MESSAGE UPDATE_SEC_STORAGE_MAP -
UPDATE_SEC_STORAGE_MAP failed.
2100 MESSAGE A general system abort occurred for XM (used
only until new aborts are added to DSYSFAIL).
2101 MESSAGE The procedure XM_RECOVERY detected an unknown