MPE/iX Error Messages Manual Vol 2 (32650-90902)

14 Chapter1
Vol. II Chapter 1
KSAM
that is less than the minimum specified for
this function.
CAUSE Self-explanatory.
ACTION Use the MPE XL Intrinsics manual to verify the set of
acceptable parameters for a given function code.
6013 MESSAGE Type manager; device is off-line.
CAUSE For printers attached via the Distributed Terminal
Controller (DTC), this is a generic error indicating the
inability of the DTC to communicate with its device. It is
currently not returned for other devices.
ACTION Check the DTC-to-device cable connections, parity and
baud rate settings, DTR and CTS settings, and
Transmit/Receive Pacing settings. Ensure that they are
set as required for proper use by the DTC.
6022 MESSAGE Type manager; unit failure.
CAUSE An undetermined device or transmission error occurred.
ACTION Check lower level statuses to determine the root cause of
the error.
6025 MESSAGE Type manager; timeout while waiting for I/O
completion.
CAUSE This usually indicates a hardware failure of some
component of the I/O subsystem.
ACTION Contact your Hewlett-Packard support engineer.
6026 MESSAGE Type manager; data transmission error.
CAUSE An undetermined transmission error was reported by a
lower level subsystem.
ACTION Check the lower level statuses to determine the root cause
of the error.
6029 MESSAGE Type manager; the device reported a power-up.
CAUSE Self-explanatory. For printers, this status is returned only
if device status reporting is disable (the default). If it is
enabled, the intrinsic interface returns CCG instead,
indicating that status is available.
ACTION The application or operator should take whatever steps
are appropriate (for example, putting the device on line).
For printers, the Native Mode Spooler will attempt to
recover to the start of the current page.
6035 MESSAGE Type manager; your I/O request was aborted
due to a system power failure.
CAUSE Self-explanatory.