MPE/iX Error Messages Manual Vol 2 (32650-90902)

Chapter 4 117
Volume II Chapter 4
System Aborts
READ the cold load ID from LDEV 1.
CAUSE The cold load ID was not read from LDEV 1.
116 MESSAGE The procedure WRITE_HPE_VOL_COLDL_ID failed
to WRITE the cold load ID from LDEV 1.
CAUSE The cold load ID was not written from LDEV 1.
117 MESSAGE The procedure FS_INITIALIZE_FILE_SYSTEM
failed to initialize the file system.
CAUSE The file system was not initialized.
118 MESSAGE The procedure FS_PROC_INIT failed to
initialize the PROCESS information block
extension area.
CAUSE The PROCESS information block extension area was not
initialized.
119 MESSAGE The procedure FAKE_LOGON failed to OPEN the
file system directories (PLFDs).
CAUSE The file system directories (PLFDs) were not opened.
120 MESSAGE The procedure INIT_LOADER failed to
initialize the LOADER.
CAUSE LOADER was not initialized.
121 MESSAGE The procedure ADD_CLASS is unable to SWITCH
to CM.
CAUSE ADD_CLASS could not SWITCH to CM.
122 MESSAGE The procedure ADD_DEVICE is unable to SWITCH
to CM.
CAUSE ADD_DEVICE could not SWITCH to CM.
123 MESSAGE The procedure ADD_DEVICE is unable to add the
system disk (LDEV 1) through ADD_DEVICE for
CM.
CAUSE The system disk could not be added through
ADD_DEVICE for CM.
124 MESSAGE The procedure ADD_DEVICE is unable to ADD the
system console through ADD_DEVICE for CM.
CAUSE The system console could not be added through
ADD_DEVICE for CM.
125 MESSAGE The procedure ADD_VIRTUAL_LDEVS is unable to
SWITCH to CM.
CAUSE ADD_VIRTUAL_DEVICE could not be switched to CM.
126 MESSAGE The procedure CLEAN_CM_DEVICE_TABLES is
unable to SWITCH to CM.