MPE/iX Error Messages Manual Vol 2 (32650-90879)

484 Chapter11
Store/Restore (Native Mode) and TurboSTORE/iX II
(S/R) cont.
1288 MESSAGE RESTORE ENCOUNTERED MISSING TAPE MARK AFTER
SSM ON REMOTE LDEV ! (S/R 1288)
CAUSE A RESTORE internal sequencing error occurred on the
specified remote drive.
ACTION Contact your HP Support Representative.
1290 MESSAGE RESTORE WAS UNABLE TO SKIP TO THE FINAL MEDIA
DIRECTORY ON LDEV ! (S/R 1290)
CAUSE RESTORE encountered an error while trying to read in
the final media directory for a backup created with
ONLINE=END on the specified device.
ACTION Make sure the correct media were mounted. If the error
persists, contact your HP Support Representative.
1291 MESSAGE RESTORE WAS UNABLE TO SKIP TO THE FINAL MEDIA
DIRECTORY ON REMOVE LDEV ! (S/R 1291)
CAUSE RESTORE encountered an error while trying to read in
the final media directory for a backup created with
ONLINE=END on the specified remote device.
ACTION Make sure the correct media were mounted. If the error
persists, contact your HP Support Representative.
1292 MESSAGE RESTORE WAS UNABLE TO SKIP TO THE FINAL MEDIA
DIRECTORY ON FILE "!" (S/R 1292)
CAUSE RESTORE encountered an error while trying to read in
the final media directory for a backup created with
ONLINE=END on the specified disk file.
ACTION Make sure the correct media were mounted. If the error
persists, contact your HP Support Representative.
1293 MESSAGE RESTORE IS UNABLE TO SKIP TO THE NEXT FILE TO
BE RESTORED ON LDEV ! DUE TO A BAD SAVE SET
MARK SKIP COUNT (S/R 1293)
CAUSE RESTORE needed to skip more than the maximum
number of save set marks allowed on one DDS tape.
ACTION If ONERR=SKIP wasspecified, then this is just a warning.
RESTORE will prompt you to mount the next tape.
However, if ONERR=QUIT was specified, then RESTORE
will abort. Retry the restore with ONERR=SKIP.
1301 MESSAGE LABELED VOLUME FREAD OF STORE LABEL FAILED ON
LDEV ! (S/R 1301)
CAUSE Internal error occurred trying to read the store label from
the first reel.
ACTION To ensure complete data retrieval use duplicate store
tapes and contact your HP Support Representative further