MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 8 307
System Startup, Shutdown, and Configuration
Class Errors
Install memory array.
2F MESSAGE No message. System halts. (E)
CAUSE No memory board is found during initialization. Second
possible cause of the error is the cache unit.
ACTION Contact your Hewlett-Packard Support Representative.
Class Error 8: Channel Adapter Test
Channel adapter test messages take the form:
8sxx
where:
s= slot number
xx = detailed error number.
NOTE The channel adapter test takes about 5 seconds to perform.
00 MESSAGE No message. System halts. (E)
CAUSE Undefined error occurs at the start of the test of this
board.
ACTION Contact your Hewlett-Packard Support Representative.
01 MESSAGE No message. System halts. (E)
CAUSE Cannot enable soft physical address. (Cannot set the SSET
bit.)
ACTION Contact your Hewlett-Packard Support Representative.
02 MESSAGE No message. System halts. (E)
CAUSE Cannot disable soft physical address. (Cannot reset SSET
bit to zero.)
ACTION Contact your Hewlett-Packard Support Representative.
03 MESSAGE No message. System halts. (E)
CAUSE Cannot verify memory with its address.
ACTION Contact your Hewlett-Packard Support Representative.
04 MESSAGE No message. System halts. (E)
CAUSE Cannot verify memory with sliding ones.
ACTION Contact your Hewlett-Packard Support Representative.
05 MESSAGE No message. System halts. (E)
CAUSE Cannot verify memory with sliding zeros.
ACTION Contact your Hewlett-Packard Support Representative.