MPE/iX Error Messages Manual Vol 2 (32650-90879)

276 Chapter8
System Startup, Shutdown, and Configuration
Class Errors
Execution Unit Failure
Execution unit messages take the form:
14xx
where:
xx = detailed error number.
00 MESSAGE No message. System halts. (E)
CAUSE Undefined error occurs at the start of the test on this
board.
ACTION Contact your Hewlett-Packard Support Representative.
01 MESSAGE No message. System halts. (E)
CAUSE Test of the data path through the barrel shifter fails.
ACTION Contact your Hewlett-Packard Support Representative.
02 MESSAGE No message. System halts. (E)
CAUSE Shift by bit 0, 1, 2, 4, 6, 8, 16, or 31 fails.
ACTION Contact your Hewlett-Packard Support Representative.
03 MESSAGE No message. System halts. (E)
CAUSE Pattern test of the 3/4-bit hardware boundaries fails.
ACTION Contact your Hewlett-Packard Support Representative.
04 MESSAGE No message. System halts. (E)
CAUSE Preshift by 0 bit for MOVE fails.
ACTION Contact your Hewlett-Packard Support Representative.
05 MESSAGE No message. System halts. (E)
CAUSE Extract sign/unsigned for a bit field fails.
ACTION Contact your Hewlett-Packard Support Representative.
06 MESSAGE No message. System halts. (E)
CAUSE Timing critical path of instruction mix MTCTL and
VEXTRS fails.
ACTION Contact your Hewlett-Packard Support Representative.
07 MESSAGE No message. System halts. (E)
CAUSE Verification of the shift amount register fails.
ACTION Contact your Hewlett-Packard Support Representative.
0A MESSAGE No message. System halts. (E)
CAUSE Arithmetic/logical conditions fail.