MPE/iX Error Messages Manual Vol 2 (32650-90879)

262 Chapter7
Volume II Chapter 5
VOLUTIL and DISCUTIL
mirrored volume set. (volutil 74)
CAUSE Non-mirrored volumes cannot be added to a mirrored
volume set.
ACTION Specify a mirrored volume.
75 MESSAGE *Error: Specified volume set is not mirrored.
(volutil 75)
CAUSE An attempt was made to perform a mirrored operation on
a non-mirrored volume set.
ACTION Cause indicates appropriate action.
76 MESSAGE *Error: Specified volume does not exist on
specified ldev. (volutil 76)
CAUSE Either the wrong volume name or the wrong LDEV was
specified.
ACTION Cause indicates appropriate action.
77 MESSAGE *Error: Command only valid for disabled
mirrored volumes. (volutil 77)
CAUSE REPLALCEMIRRVOL was issued for a non-disabled
volume.
ACTION Cause indicates appropriate action.
78 MESSAGE *Error: Illegal replace. Mirrored partner is
not available. (volutil 78)
CAUSE REPLALCEMIRRVOL was issued but good volume was
not mounted as MEMBER or MASTER.
ACTION Verify that volume used is good.
79 MESSAGE *Error: Mirrored volume must be in pending
state. (volutil 79)
CAUSE The volume specified in the SUSPENDMIRROR command
was not in a pending state.
ACTION Be sure specified volume is pending before issuing
command.
80 MESSAGE *Error: Command not supported for mirrored
volume sets. (volutil 80)
CAUSE The COPYSET command is not supported for mirrored
volume sets.
ACTION Use a different command.
83 MESSAGE *Error: Illegal replace. MIrrored pair is
already in operation. (volutil 83)
CAUSE REPLACEMIRRORVOL was issued on an already functioning
mirrored pair.