MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 6 213
Volume II Chapter 5
Threshold Manager
(THMGRERR 16)
CAUSE The Threshold Manager process failed during program
initialization.
ACTION Exit the program and restart the application.
17 MESSAGE The new control option is invalid. (THMGRERR
17)
CAUSE Internal error. It is possible that the file
THMGRCTL.PUB.SYS has become corrupted.
ACTION Restore a backup copy of the THMGRCTL.PUB.SYS file.
18 MESSAGE Invalid threshold value was specified.
(THMGRERR 18)
CAUSE The threshold value provided with this resource does not
match the previously configured threshold value.
ACTION Check the current configuration of this resource by using
the SHOW command and enter the correct threshold value.
19 MESSAGE Invalid frequency was specified. (THMGRERR
19)
CAUSE The time interval specified is not valid.
ACTION Enter the command again with a valid time interval
between 25 and 3600 seconds.
52 MESSAGE Request for enabling a resource has been
denied. (THMGRERR 52)
CAUSE The resource information on internal tables was found to
be incomplete or inconsistent. There could be data
corruption.
ACTION Delete all the thresholds for this resource and reconfigure.
53 MESSAGE Threshold Manager process is dead. (THMGRERR
53)
CAUSE The Threshold Manager process aborted for some
unknown reason.
ACTION Exit the program and restart the application.
101 MESSAGE Bad procedure label encountered while
monitoring the
usage-level of resource "!". (THMGRERR 101)
CAUSE Threshold Manager internal error. Note that the resource
name may not be the same in all occurrances of this error.
ACTION Disable Threshold Manager and restart.
102 MESSAGE Bad procedure label encountered while
executing the jumpoff