MPE/iX Error Messages Manual Vol 2 (32650-90879)

212 Chapter6
Volume II Chapter 5
Threshold Manager
THMGRRES.PUB.SYS has become corrupted.
ACTION Restore a backup copy of the THMGRRES.PUB.SYS file.
8 MESSAGE Control information does not match resource.
(THMGRERR 8)
CAUSE Internal error. It is possible that the file
THMGRCTL.PUB.SYS has become corrupted.
ACTION Restore a backup copy of the THMGRCTL.PUB.SYS file
9 MESSAGE Communication error with Threshold Manager.
(THMGRERR 9)
CAUSE A communication error occurred with the Threshold
Manager.
ACTION Exit the program and restart the application.
10 MESSAGE Duplicate threshold information. (THMGRERR
10)
CAUSE The threshold value specified is already part of the current
configuration for this resource.
ACTION Check the current configuration for this resource, and
enter the correct threshold value.
11 MESSAGE The number of thresholds is at maximum
capacity. (THMGRERR 11)
CAUSE Internal error. The table which holds the thresholds is at
maximum capacity.
ACTION Delete the unnecessary thresholds and try again.
12 MESSAGE Threshold does not exist. (THMGRERR 12)
CAUSE The threshold value supplied for this resource is
non-existent.
ACTION Check the current configuration of this resource by using
the SHOW command and enter the correct threshold value.
13 MESSAGE Threshold Manager encountered an unknown
error. (THMGRERR13)
CAUSE A trap has been detected from another external procedure.
ACTION None
14 MESSAGE Creation of the Threshold Manager process
failed. (THMGRERR 14)
CAUSE Creation of the Threshold Manager process failed during
the program initialization.
ACTION Exit the program and restart the application.
16 MESSAGE Threshold Manager process is not active.